ABB ACQ580 Firmware Manual page 249

No. Name/Value
51.02 FBA A Par2
0...65535
... ...
51.26 FBA A Par26
0...65535
51.27 FBA A par refresh
Done
Configure
51.28 FBA A par table ver
51.29 FBA A drive type
code
0...65535
51.30 FBA A mapping file
ver
0...65535
51.31 D2FBA A comm
status
Not configured
Initializing
Time out
Configuration error
Off-line
On-line
Reset
51.32 FBA A comm SW
ver
Description
Parameters 51.02...51.26
more information, see the documentation of the fieldbus
adapter module. Note that not all of these parameters are
necessarily in use.
Fieldbus adapter configuration parameter.
...
See parameter 51.02 FBA A
Fieldbus adapter configuration parameter.
Validates any changed fieldbus adapter module configuration
settings. After refreshing, the value reverts automatically to
Done.
Note: This parameter cannot be changed while the drive is
running.
Refreshing done.
Refreshing.
Displays the parameter table revision of the fieldbus adapter
module mapping file (stored in the memory of the drive).
In format axyz, where ax = major table revision number; yz =
minor table revision number.
This parameter is read-only.
Parameter table revision of adapter module.
Displays the drive type code in the fieldbus adapter module
mapping file (stored in the memory of the drive).
This parameter is read-only.
Drive type code stored in the mapping file.
Displays the fieldbus adapter module mapping file revision
stored in the memory of the drive in decimal format.
This parameter is read-only.
Mapping file revision.
Displays the status of the fieldbus adapter module
communication.
Adapter is not configured.
Adapter is initializing.
A timeout has occurred in the communication between the
adapter and the drive.
Adapter configuration error: mapping file not found in the file
system of the drive, or mapping file upload has failed more
than three times.
Fieldbus communication is off-line.
Fieldbus communication is on-line, or fieldbus adapter has
been configured not to detect a communication break. For
more information, see the documentation of the fieldbus
adapter.
Adapter is performing a hardware reset.
Displays the common program revision of the adapter module
in format axyz, where a = major revision number, xy = minor
revision number, z = correction number or letter.
Example: 190A = revision 1.90A.
Common program revision of adapter module.
are adapter module-specific. For
Par2.
Parameters 245
Def/FbEq16
-
1 = 1
...
-
1 = 1
Done
0
1
-
-
-
1 = 1
-
1 = 1
Not
configured
0
1
2
3
4
5
6
-