ABB ACQ580 Firmware Manual page 147
Pump control program
Hide thumbs
Also See for ACQ580:
- Quick start up manual (92 pages) ,
- Manual (5 pages) ,
- Electrical planning instructions (36 pages)
Table of Contents
Advertisement
No.
Name/Value
In1P Start; In2 Stop The sources of the start and stop commands are selected by
Reserved
Control panel
Fieldbus A
Reserved
Embedded fieldbus
20.02
Ext1 start trigger
type
Edge
Level
20.03
Ext1 in1 source
Not selected
Selected
DI1
DI2
DI3
DI4
DI5
DI6
Reserved
Timed function 1
Timed function 2
Timed function 3
Reserved
Supervision 1
Description
parameters
20.03 Ext1 in1 source
The state transitions of the source bits are interpreted as
follows:
State of source 1
(20.03)
0 - > 1
Any
Notes:
• Parameter
20.02 Ext1 start trigger type
this setting.
• When source 2 is 0, the Start and Stop keys on the control
panel are disabled.
The start and stop commands are taken from the control
panel (or PC connected to the panel connector).
Note: This selection requires ACS-AP-I panel that uses
Start/Stop/Loc/Rem logic.
The start and stop commands are taken from fieldbus adapter
A.
Note: Set also
20.02 Ext1 start trigger type
The start and stop commands are taken from the embedded
fieldbus interface.
Note: Set also
20.02 Ext1 start trigger type
Defines whether the start signal for external control location
EXT1 is edge-triggered or level-triggered.
Note: This parameter is not effective if a pulse-type start
signal is selected. See the descriptions of the selections of
parameter
20.01 Ext1
commands.
The start signal is edge-triggered.
The start signal is level-triggered.
Selects source 1 for parameter
0 (always off).
1 (always on).
Digital input DI1
(10.02 DI delayed
Digital input DI2
(10.02 DI delayed
Digital input DI3
(10.02 DI delayed
Digital input DI4
(10.02 DI delayed
Digital input DI5
(10.02 DI delayed
Digital input DI6
(10.02 DI delayed
Bit 0 of
34.01 Timed functions status
Bit 1 of
34.01 Timed functions status
Bit 2 of
34.01 Timed functions status
Bit 0 of
32.01 Supervision status
and
20.04 Ext1 in2
State of source 2
Command
(20.04)
1
0
has no effect with
to Level.
to Level.
20.01 Ext1
commands.
status, bit 0).
status, bit 1).
status, bit 2).
status, bit 3).
status, bit 4).
status, bit 5).
(see page 191).
(see page 191).
(see page 191).
(see page 184).
Parameters 143
Def/FbEq16
4
source.
Start
Stop
5...10
11
12
13
14
Level
0
1
DI1
0
1
2
3
4
5
6
7
8...17
18
19
20
21...23
24
Advertisement
Table of Contents
