ABB ACQ580 Firmware Manual page 122

118 Parameters
No. Name/Value
10.04 DI forced data
Bit Value
0 Force the value of this bit to D1, if so defined in parameter
1 Force the value of this bit to D3, if so defined in parameter
2 Force the value of this bit to D3, if so defined in parameter
3 Force the value of this bit to D4, if so defined in parameter
4 Force the value of this bit to D5, if so defined in parameter
5 Force the value of this bit to D6, if so defined in parameter
6...15 Reserved
0000h...FFFFh
10.21 RO status
Bit Value
0 1 = RO1 is energized.
1 1 = RO2 is energized.
2 1 = RO3 is energized.
3...15 Reserved
0000h...FFFFh
10.22 RO force selection
Bit Value
0 1 = Force RO1 to value of bit 0 of parameter
1 1 = Force RO2 to value of bit 1 of parameter
2 1 = Force RO3 to value of bit 2 of parameter
3...15 Reserved
0000h...FFFFh
Description
Allows the data value of a forced digital input to be changed
from 0 to 1. It is only possible to force an input that has been
selected in parameter 10.03 DI force
Bit 0 is the forced value for DI1; bit 5 is the forced value for
the DI6.
Forced values of digital inputs.
Status of relay outputs RO3...RO1.
Status of relay outputs.
The signals connected to the relay outputs can be overridden
for eg. testing purposes. A bit in parameter
data is provided for each relay output, and its value is applied
whenever the corresponding bit in this parameter is 1.
Note: Boot and power cycle reset the force selections
(parameters 10.22 and 10.23).
Override selection for relay outputs.
selection.
10.03 DI force
10.03 DI force
10.03 DI force
10.03 DI force
10.03 DI force
10.03 DI force
10.23 RO forced
10.23 RO forced data. (0 = Normal mode)
10.23 RO forced data. (0 = Normal mode)
10.23 RO forced data. (0 = Normal mode)
Def/FbEq16
0000h
selection.
selection.
selection.
selection.
selection.
selection.
1 = 1
-
1 = 1
0000h
1 = 1