Control Word And Status Word - ABB ACQ580 Firmware Manual
Pump control program
Hide thumbs
Also See for ACQ580:
- Quick start up manual (92 pages) ,
- Manual (5 pages) ,
- Electrical planning instructions (36 pages)
Table of Contents
Advertisement
394 Fieldbus control through a fieldbus adapter
Control word and Status word
The Control word is the principal means for controlling the drive from a fieldbus
system. It is sent by the fieldbus master station to the drive through the adapter
module. The drive switches between its states according to the bit-coded instructions
in the Control word, and returns status information to the master in the Status word.
The contents of the Control word and the Status word are detailed on pages
397
and
398
respectively. The drive states are presented in the state diagram (page 399).
Debugging the network words
If parameter
50.12 FBA A debug mode
is set to Fast, the Control word received from
the fieldbus is shown by parameter
50.13 FBA A control
word, and the Status word
transmitted to the fieldbus network by
50.16 FBA A status
word. This "raw" data is
very useful to determine if the fieldbus master is transmitting the correct data before
handing control to the fieldbus network.
Advertisement
Table of Contents
