Feature Summary
MSC adds support for parallel rectifiers (legacy, non-serial rectifiers) to the functionality of the M2
controller platform. This controller supports ABB's most extensive controller feature set.
Standard System Features
Monitoring and control of parallel
rectifiers
Monitoring and control of up to 90 RS-
485 serial connected GP devices
Alarms
Rectifiers
Contactor/Disconnect Control
Interfaces
Page 15
© Copyright 2023 ABB. All rights reserved.
Table 1 MSC Standard System Features
•
Maximum of 16 parallel rectifiers (legacy, non-serial
rectifiers), ABB or commercial, including ECS SR 364
series
•
Maximum of 2 BJCn_MSC cards (within the
Controller)
•
Maximum of 90 serial switch mode rectifiers.
Supported rectifier families:
570, 595, 596, NP, CPS6000, QS, AC, and NE
•
Maximum of 32 Bay Interface Cards (BICs)
•
Maximum of 72 serial converters
•
Maximum of 8 ringers
•
Maximum of 6 LVD distribution cards
•
Maximum of 8 VIM1s
•
Standard and custom User Defined system alarms
•
Alarm test
•
Alarm cut-off
•
Multiple-level alarm severity: Critical, Major, Minor,
Warning, and Record-Only
•
Automatic rectifier restart
•
Reserve engine transfer
•
High Voltage Shutdown
•
Energy management
•
Remote rectifier (on/off) control
•
Automatic rectifier sequence control
•
N + X redundancy check
•
Digital voltage regulation and rectifier load share
•
Low Voltage Load
•
Low Voltage Battery
•
Enhanced Front Panel Display
•
Local PC Port
•
Modem
•
LAN (Gateway)
•
X.25/TL1
Millennium SC_MAN
Rev 2.0