Pump Cleaning - ABB ACQ580 Firmware Manual

No. Name/Value
82.37 Outlet maximum
pressure warning
level
0.00...32767.00 bar
82.38 Outlet maximum
pressure fault level
0.00...32767.00 bar
82.40 Inlet minimum
pressure protection
Disabled
Warning
Fault
Warning/Fault
82.41 Inlet minimum
pressure warning
level
0.00...32767.00 bar
82.42 Inlet minimum
pressure fault level
0.00...32767.00 bar
82.45 Pressure check
delay
0.00...3600.00 s
83

83 Pump cleaning

83.01 Pump cleaning
status
Disabled
Pump clean
No triggers
configured
Waiting for
triggering
Description
Defines the level at which drive should generate the outlet
maximum pressure warning.
Outlet maximum pressure warning level.
Defines the level at which drive should generate the outlet
maximum pressure fault.
Outlet maximum pressure fault level.
Enables inlet minimum pressure protection function.
Inlet minimum pressure protection is disabled.
Inlet minimum pressure protection function generates
Inlet minimum pressure
the level defined with parameter
pressure warning level for a time set in
delay.
Inlet minimum pressure protection function generates
Inlet minimum pressure
level defined with parameter
fault level for a time set in
Inlet minimum pressure protection function first generates a
warning when the pressure is below the level defined with
parameter 82.41 Inlet minimum pressure warning level
time set in 82.45 Pressure check
If the pressure continues to fall below the level defined with
parameter 82.42 Inlet minimum pressure fault
generated.
Defines the level at which drive should generate the inlet
minimum pressure warning.
Inlet minimum pressure warning level.
Defines the level at which drive should generate the inlet
minimum pressure fault.
Inlet minimum pressure fault level.
Defines the delay time at which the pressure supervisions are
inactive.
You can adjust check delay for a system in which the
pressure does not increase immediately after starting the
motor.
Pressure check delay time.
Settings for the pump cleaning sequence.
See section Pump cleaning
Displays the status of pump cleaning.
Cleaning sequence is disabled.
Cleaning sequence is active.
Triggers are not configured.
Waiting for triggering signal.
warning when the pressure is below
82.41 Inlet minimum
82.45 Pressure check
fault when the pressure is below the
82.42 Inlet minimum pressure
82.45 Pressure check
delay.
level, a fault is
(page 54).
Parameters 277
Def/FbEq16
0.00
1 = 1 bar
0.00
1 = 1 bar
Disabled
0
D510 1
D40A 2
delay.
3
for a
0.00
1 = 1 bar
0.00
1 = 1 bar
3.00
1 = 1 s
Disabled
0
1
2
3