ABB ACQ580 Firmware Manual page 238

234 Parameters
No. Name/Value
45.12 Energy tariff 1
0.000...
4294966.296 units
45.13 Energy tariff 2
0.000...
4294966.296 units
45.14 Tariff selection
Energy tariff 1
Energy tariff 2
DI1
DI2
DI3
DI4
DI5
DI6
Other [bit]
45.18 CO2 conversion
factor
0.000...65.535
tn/MWh
45.19 Comparison power
0.00...10000000.00
kW
45.21 Energy calculations
reset
Done
Reset
Description
Defines energy tariff 1 (price of energy per kWh). Depending
on the setting of parameter
value or 45.13 Energy tariff 2
monetary savings are calculated.
If you have not set the currency during the first start-up, you
can specify it in Main menu - Primary settings - Clock,
region display - Units - Currency.
Note: Tariffs are read only at the instant of selection, and are
not applied retroactively.
Energy tariff 1.
Defines energy tariff 2 (price of energy per kWh).
See parameter 45.12 Energy tariff
Energy tariff 2.
Selects (or defines a source that selects) which pre-defined
energy tariff is used.
0 = 45.12 Energy tariff 1
1 = 45.13 Energy tariff 2
0.
1.
Digital input DI1 (10.02 DI delayed
Digital input DI2 (10.02 DI delayed
Digital input DI3 (10.02 DI delayed
Digital input DI4 (10.02 DI delayed
Digital input DI5 (10.02 DI delayed
Digital input DI6 (10.02 DI delayed
Source selection (see Terms and abbreviations
Defines a factor for conversion of saved energy into CO
emissions (kg/kWh or tn/MWh).
Factor for conversion of saved energy into CO
Actual power that the motor absorbs when connected direct-
on-line and operating the application. The value is used for
reference when energy savings are calculated.
Note: The accuracy of the energy savings calculation is
directly dependent on the accuracy of this value. If nothing is
entered here, then the nominal motor power is used by the
calculation, but that may inflate the energy savings reported
as many motors do not absorb nameplate power.
Motor power.
Resets the savings counter parameters 45.01...45.10.
Reset not requested (normal operation), or reset complete.
Reset the savings counter parameters. The value reverts
automatically to Done.
45.14 Tariff selection, either this
is used for reference when
1.
status, bit 0).
status, bit 1).
status, bit 2).
status, bit 3).
status, bit 4).
status, bit 5).
on page 100). -
emissions.
2
Def/FbEq16
0.100 units
-
0.200 units
-
Energy tariff
1
0
1
2
3
4
5
6
7
0.500
2
tn/MWh
(metric ton)
1 = 1 tn/MWh
0.00 kW
1 = 1 kW
Done
0
1