ABB ACQ580 Firmware Manual page 150

146 Parameters
No. Name/Value
-DI2
-DI3
-DI4
-DI5
-DI6
Fieldbus adapter
Embedded fieldbus
Other [bit]
20.42 Start interlock 2
20.43 Start interlock 3
20.44 Start interlock 4
20.45 Start interlock stop
mode
Not used
Coast
Ramp
20.46 Run permissive text
Run permissive
Valve opening
Pre-lube cycle
20.47 Start interlock 1 text
Start interlock 1
Vibration switch
Firestat
Freeze stat
Overpressure
Vibration trip
Smoke alarm
Auxiliary open
Low suction
Low pressure
Access door
Pressure relief
Motor disconnect
open
Description
Digital input DI2 (10.02 DI delayed
Digital input DI3 (10.02 DI delayed
Digital input DI4 (10.02 DI delayed
Digital input DI5 (10.02 DI delayed
Digital input DI6 (10.02 DI delayed
This selection cannot be used to control Start interlock with
ABB drives profile from the fieldbus adapter. Use
and map to control word user bits.
Start interlock 1: DCU profile: Inverse of control word bit 18
received through the embedded fieldbus interface.
Start interlock 2: Inverse of bit 19.
Source selection (see Terms and abbreviations
Selects the source of the Start interlock 2 signal.
For the selections, see parameter
Selects the source of the Start interlock 3 signal.
For the selections, see parameter
Selects the source of the Start interlock 4 signal.
For the selections, see parameter
Selects the method of stopping if a Start interlock signal is
lost. Applies to 20.41 Start interlock
20.43 Start interlock 3 and
Not in use.
The motor coasts to a stop.
Stop along the active deceleration ramp.
Alternative alarm texts for the run permissive.
Alternative alarm texts for the start interlock 1.
status, bit 1).
status, bit 2).
status, bit 3).
status, bit 4).
status, bit 5).
Other [bit]
on page 100). -
20.41 Start interlock
20.41 Start interlock
20.41 Start interlock
1, 20.42 Start interlock
20.44 Start interlock 4.
Def/FbEq16
9
10
11
12
13
14
15
Selected
1.
Selected
1.
Selected
1.
Not used
2,
0
1
2
Run
permissive
0
2
3
Start
interlock 1
0
1
2
3
4
5
6
7
8
9
10
11
12