Standard Di, Ro - ABB ACQ580 Firmware Manual

No. Name/Value
10

10 Standard DI, RO

10.02 DI delayed status
Bit Name
0 DI1
1 DI2
2 DI3
3 DI4
4 DI5
5 DI6
6...15 Reserved
0000h...FFFFh
10.03 DI force selection
Bit Value
0 1 = Force DI1 to value of bit 0 of parameter
1 1 = Force DI2 to value of bit 1 of parameter
2 1 = Force DI3 to value of bit 2 of parameter
3 1 = Force DI4 to value of bit 3 of parameter
4 1 = Force DI5 to value of bit 4 of parameter
5 1 = Force DI6 to value of bit 5 of parameter
6...15 Reserved
0000h...FFFFh
Description
Configuration of digital inputs and relay outputs.
Displays the status of digital inputs DI1...DI6. Bits 0...5 reflect
the delayed status of DI1...DI6.
Example: 0000000000010011b = DI5, DI2 and DI1 are on,
DI3, DI4 and DI6 are off.
This word is updated only after a 2 ms activation/deactivation
delay. When the value of a digital input changes, it must
remain the same in two consecutive samples, that is for 2 ms,
for the new value to be accepted.
This parameter is read-only.
Description
1 = Digital input 1 is ON.
1 = Digital input 2 is ON.
1 = Digital input 3 is ON.
1 = Digital input 4 is ON.
1 = Digital input 5 is ON.
1 = Digital input 6 is ON.
Delayed status for digital inputs.
The electrical statuses of the digital inputs can be overridden
for eg. testing purposes. A bit in parameter
data is provided for each digital input, and its value is applied
whenever the corresponding bit in this parameter is 1.
Note: Boot and power cycle reset the force selections
(parameters 10.03 and 10.04).
Override selection for digital inputs.
10.04 DI forced
10.04 DI forced data. (0 = Normal mode)
10.04 DI forced data. (0 = Normal mode)
10.04 DI forced data. (0 = Normal mode)
10.04 DI forced data. (0 = Normal mode)
10.04 DI forced data. (0 = Normal mode)
10.04 DI forced data. (0 = Normal mode)
Parameters 117
Def/FbEq16
-
1 = 1
0000h
1 = 1