ABB ACQ580 Firmware Manual page 290

286 Parameters
No. Name/Value
96.16 Unit selection
Bit Name
0 Power unit
1 Reserved
2 Temperature
unit
3 Reserved
4 Torque unit
5...15 Reserved
0000h...FFFFh
96.20 Time sync primary
source
Internal
Fieldbus A
Embedded FB
Panel link
Ethernet tool link
96.51 Clear fault and
event logger
Done
Clear
0...1
96.70 Disable adaptive
program
No
Yes
96.100 Change user pass
code
10000000...
99999999
96.101 Confirm user pass
code
10000000...
99999999
Description
Selects the unit of parameters indicating power, temperature
and torque.
Information
0 = kW
1 = hp
0 = °C
1 = °F
0 = Nm (N·m)
1 = lbft (lb·ft)
Unit selection word.
Defines the 1st priority external source for synchronization of
the drive's time and date.
No external source selected.
Fieldbus interface A.
Embedded fieldbus interface.
Control panel, or Drive composer PC tool connected to the
control panel.
Drive composer PC tool through an FENA module.
Clears all events from the drive's fault and event logs.
0 = No action
1 = Clear the loggers.
Enables/disables the adaptive program (if present).
See also section Adaptive programming
Adaptive program enabled.
Adaptive program disabled.
(Visible when user lock is open)
To change the current user pass code, enter a new code into
this parameter as well as
warning will be active until the new pass code is confirmed.
To cancel changing the pass code, close the user lock without
confirming. To close the lock, enter an invalid pass code in
parameter 96.02 Pass code, activate parameter
Control board boot, or cycle the power.
See also section User lock
New user pass code.
(Visible when user lock is open)
Confirms the new user pass code entered in
user pass code.
Confirmation of new user pass code.
(page 43).
96.101 Confirm user pass
96.08
(page 97).
96.100 Change
Def/FbEq16
0000b
1 = 1
Panel link
0
2
6
8
9
Done
0
1
1 = 1
Yes
0
1
10000000
code. A
-
-