Cleaning; Symbols - ABB ControlMaster CM10 Commissioning Instructions

6 C O N T R O L M A S T E R C M 1 0 | U N I V E R S A L P R O C E S S C O N T R O L L E R , 1/8 D I N | C I/C M 1 0 - E N R E V. C
...1 Health & Safety
...End-of-life disposal
ABB is committed to ensuring that the risk of any
environmental damage or pollution caused by any
of its products is minimized as far as possible. The
European Waste Electrical and Electronic
Equipment (WEEE) Directive that initially came into
force on 13 August 2005 aims to reduce the waste
arising from electrical and electronic equipment;
and improve the environmental performance of all
those involved in the life cycle of electrical and
electronic equipment.
In conformity with European local and national
regulations, electrical equipment marked with the
above symbol may not be disposed of in European
public disposal systems after 12th August 2005

Cleaning

The controller can be hosed down if it has been
installed to IP66/NEMA 4X standards. Warm water and
a mild detergent can be used.

Symbols

Symbols that appear on this product are shown below:
Protective earth (ground) terminal.
Both direct and alternating current supply.
This symbol, when noted on a product, indicates a
potential hazard that could cause serious personal
injury and/or death. The user must refer to this
commissioning instruction for operation and/or
safety information.
This symbol, when noted on a product enclosure or
barrier, indicates that a risk of electrical shock
and/or electrocution exists. Only individuals
qualified to work with hazardous voltages should
open the enclosure or remove the barrier.
Recycle separately from general waste under the
WEEE directive