Controls; Main Power Switch; Control Panel; Switches - Thermo Scientific EASYpure 1164 Series Operation Manual And Parts List

Controls

Main Power Switch

The main power switch on the EASYpure UV/UF is located on
the back right of the unit (as you face the front of the unit),
directly above the power cord receptacle.

Control Panel

The EASYpure UV/UF is controlled through a control panel
which incorporates three switches, three indicating LEDʼs and
a digital display.

Switches

When the main power switch (on the back of the unit) is on,
the three switches on the control panel function as follows:
Start/Stop
When the unit is in the Off Mode, pressing
the START/STOP switch will put the unit in the run mode,
starting the pump and energizing the display. When the
EASYpure UV/UF is in the Standby Mode, pressing the
START/STOP switch will return the unit to run mode.
When the unit is in the run mode, pressing the START/STOP
switch will put the unit into the Off Mode.
Standby
Pressing the Standby switch will place the unit in Standby
Mode from either the Run Mode or the Off Mode. Pressing the
Standby switch while the unit is in Standby Mode has no fur-
ther effect.
Flush
Pressing the Flush switch once will initiate a one minute flush
of the ultrafilter. During this one minute flush, water is sent to
drain through the reject tubing, the Manual/Extended Flush
LED will be lit, and the display will be dark.
Pressing the Flush switch twice will initiate a five minute flush
of the ultrafilter. During this five minute flush, water is sent to
drain through the reject tubing, the Manual/Extended Flush
LED will flash, and the display will be dark. After the timed
14