Table of Contents
Advertisement
Wall Mounting
(continued)
Install Control Panel
in Remote Location
Thermo Scientific
4. Remove the locking screws on each side of the wall bracket.
5. Pull the two locking slides on each side of the wall bracket out as far as
they will go.
6. Hang the unit on the wall bracket by sliding the mounting pins into
the wall bracket slots.
7. Push the locking slides on each side of the wall bracket in as far as they
will go.
8. Replace the locking screws.
Note The removable control panel was not designed to be repeatedly
removed from the unit, therefore, you may experience difficulty when
attempting to remove it. It is therefore recommended that the control
panel be permanently mounted in a remote location or remain intact with
the unit.
Caution Repeated removal and replacement of the control panel from the
top cover may eventually cause it to become damaged.
Note A bracket is
available that will
allow you to mount
the control panel on
the bench. If bench
mounting is desired,
order bracket
AY1367X2.
Note The blank
protective cover on the
rear side panel display
connector should
remain in place when
the display is not
remotely located.
Wall Mount
Bracket
Nanopure Life Science (UV/UF)
Section 5
Installation
Blank panel
Figure 5-5. Wall Mounting
5-5
Advertisement
Table of Contents
