Vacon NX Series Applications Manual page 364

VACON · 364 PARAMETER DESCRIPTIONS
The relative gain of the speed controller as a percentage of parameter ID613 when the speed
is below the level defined by ID1300.
1300 SPEED CONTROLLER F0 POINT 6 (2.6.23.26)
Use this parameter to set the speed level below which the speed controller gain is equal to
speed controller gain F0.
The speed level in Hz below which the speed controller gain is equal to parameter ID1299.
1301 SPEED CONTROLLER F1 POINT 6 (2.6.23.25)
Use this parameter to set the speed level above which the speed controller gain is equal to
Speed control P gain.
The speed level in Hz above which the speed controller gain is equal to parameter ID613.
From the speed defined by parameter ID1300 to speed defined by parameter ID1301, the
speed controller gain changes linearly from parameters ID1299 to ID613 and vice versa.
1304 WINDOW POSITIVE 6 (2.10.12)
Use this parameter to set the size of the window to the positive direction from the final speed
reference.
1305 WINDOW NEGATIVE 6 (2.10.11)
Use this parameter to set the size of the window to the negative direction from the final
speed reference.
1306 WINDOW POSITIVE OFF LIMIT 6 (2.10.14)
Use this parameter to set the positive off limit to the speed controller when the speed comes
back to the window.
1307 WINDOW NEGATIVE OFF LIMIT 6 (2.10.13)
Use this parameter to set the negative off limit to the speed controller when the speed
comes back to the window.
1311 SPEED ERROR FILTER TC 6 (2.6.23.33)
Use this parameter to set the filtering time for the speed reference and the actual speed
error.
Can be used to remove small disturbances in the encoder signal.
1382 SPEED CONTROL OUTPUT LIMIT 6 (2.10.15)
Use this parameter to set a maximum torque limit for the speed controller output as a
percentage of the motor nominal torque.
9
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/