Vacon NX Series Applications Manual page 342

VACON · 342 PARAMETER DESCRIPTIONS
1240 INCHING REFERENCE 2 6 (2.4.16)
Use this parameter to set the frequency references for the inching function.
The parameter is available for NXP drives only.
1241 SPEED SHARE 6 (2.11.5)
Use this parameter to set additional scaling to the frequency reference.
Defines the percentage for final speed reference from received speed reference.
1244 TORQUE REFERENCE FILTERING TIME 6 (2.10.10)
Use this parameter to set the filtering time for the torque reference.
1248 LOAD SHARE 6 (2.11.6)
Use this parameter to set additional scaling to the torque reference.
Defines the percentage for final torque reference from received torque reference.
1250 FLUX REFERENCE 6 (2.6.23.32)
Use this parameter to set scaling to the magnetising current of the motor.
1252 SPEED STEP 6 (2.6.15.1, 2.6.25.25)
Use this parameter to adjust the speed controller when NCDrive is used.
See closer NCDrive Tools: Step response. With this tool you can give a step value to speed
reference after ramp control.
1253 TORQUE STEP 6 (2.6.25.26)
Use this parameter to adjust the torque controller when NCDrive is used.
See closer NCDrive Tools: Step response. With this tool you can give step to torque
reference.
1257 INCHING RAMP 6 (2.4.17)
Use this parameter to set the ramp time when inching is active.
The parameter is available for NXP drives only.
1276 EMERGENCY STOP MODE 6 (2.4.18)
Use this parameter to select how the drive stops when the emergency stop command is
given from DI or Fieldbus.
Defines the action after the IO emergency input goes low. The parameter is available for NXP
drives only.
9
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/