Vacon NX Series Applications Manual page 275

PARAMETER DESCRIPTIONS VACON · 275
471 ANALOGUE OUTPUT 2 SIGNAL SELECTION * 234567 (2.3.12, 2.3.22, 2.3.6.1, 2.3.4.1)
Use this parameter to connect the analogue output signal to the analogue output of your
choice.
For more information about the TTF programming method, see Chapter 9.9 "Terminal to
function" (TTF) programming principle.
472 ANALOGUE OUTPUT 2 FUNCTION 234567 (2.3.13, 2.3.23, 2.3.6.2, 2.3.4.2)
Use this parameter to select the function for the analogue output signal.
473 ANALOGUE OUTPUT 2 FILTER TIME 234567 (2.3.13, 2.3.23, 2.3.6.3, 2.3.4.3)
Use this parameter to set the filtering time of the analogue output signal.
474 ANALOGUE OUTPUT 2 INVERSION 234567 (2.3.15, 2.3.25, 2.3.6.4, 2.3.4.4)
Use this parameter to invert the analogue output signal.
475 ANALOGUE OUTPUT 2 MINIMUM 234567 (2.3.16, 2.3.26, 2.3.6.5, 2.3.4.5)
Use this parameter to set the minimum value of the analogue output signal.
476 ANALOGUE OUTPUT 2 SCALING 234567 (2.3.17, 2.3.27, 2.3.6.6, 2.3.4.6)
Use this parameter to set the scaling factor for the analogue output.
For more information on these five parameters, see the corresponding parameters for the
analogue output 1 (IDs 307-311).
477 ANALOGUE OUTPUT 2 OFFSET 67 (2.3.6.7, 2.3.4.7)
Use this parameter to add offset to the analogue output.
Add –100.0 to 100.0% to the analogue output.
478 ANALOGUE OUTPUT 3, SIGNAL SELECTION * 67 (2.3.7.1, 2.3.5.1)
Use this parameter to connect the analogue output signal to the analog output of your
choice.
See ID464.
479 ANALOGUE OUTPUT 3, FUNCTION 67 (2.3.7.2, 2.3.5.2)
Use this parameter to select the function for the analogue output signal.
See ID307.
480 ANALOGUE OUTPUT 3, FILTER TIME 67 (2.3.7.3, 2.3.5.3)
Use this parameter to set the filtering time of the analogue output signal.
Setting this parameter value 0 will deactivate filtering. See ID308.
9
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/