Vacon NX Series Applications Manual page 316

VACON · 316
NOTE!
The parameter name TBoard1 Warn.Lim is used in Multi-Purpose Control
Application. The old name (PT100 warning limit) is still used in PID Control
Application and Pump and Fan Control Application.
742 TBOARD1 FLT.LIM (PT100 FAULT LIMIT) 567 (2.7.27)
Use this parameter to set the temperature fault limit.
NOTE!
The parameter name TBoard1 Flt.Lim is used in Multi-Purpose Control Application.
The old name (PT100 fault limit) is still used in PID Control Application and Pump
and Fan Control Application.
743 TBOARD2 NUMBERS 6 (2.7.37)
Use this parameter to select the number of sensors in use when a temperature board is
installed.
If you have a temperature board installed in your AC drive you can choose here the number
of sensors in use. See also the VACON
Table 188: Selections for parameter ID743
Selection
number
0 Not used
1 Channel 1
2 Channel 1 & 2
3 Channel 1 & 2 & 3
4 Channel 2 & 3
5 Channel 3
NOTE!
If the selected value is greater than the actual number of used sensors, the display
will read 200ºC. If the input is short-circuited the displayed value is –30ºC.
745 TBOARD2 WARN. LIM 6 (2.7.38)
Use this parameter to set the temperature warning limit.
746 TBOARD2 FLT.LIM 6 (2.7.39)
Use this parameter to set the temperature fault limit.
9
NX I/O Boards User Manual.
®
Selection name
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
PARAMETER DESCRIPTIONS
Description