Vacon NX Series Applications Manual page 266

VACON · 266
Analogue input level zero corresponds to ramp times set by parameters. Maximum level
means a tenth of value set by parameter.
Fig. 62: Reducing of acceleration and deceleration times
402 SCALING OF TORQUE SUPERVISION LIMIT 6 (2.2.6.4)
Use this parameter to select the signal to adjust the torque supervision limit.
See ID399.
The set torque supervision limit can be reduced with the free analogue input signal between
0 and the set supervision limit, ID349.
Fig. 63: Reducing torque supervision limit
403 START SIGNAL * 16 (2.2.7.1)
Use this parameter to select the digital input signal (Control Signal 1) that starts and stops
the drive when the control place is I/O A (FWD).
Default programming A.1.
404 START SIGNAL * 26 (2.2.7.2)
Use this parameter to select the digital input signal (Control Signal 2) that starts and stops
the drive when the control place is I/O A (REV).
Default programming A.2.
9
Factor R
10
2
1
0 Signal range
Torque
limit
100%
Par. ID349
0 Signal range
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
PARAMETER DESCRIPTIONS
Free
analogue
input
Free
analogue
input