Vacon NX Series Applications Manual page 203

MONITORING VALUE DESCRIPTIONS VACON · 203
62 AI4 (V1.21.19)
This monitoring value shows the value of the analogue input signal as a percentage of the
used range.
69 SENSOR 4 TEMPERATURE (V1.21.25)
This monitoring value shows the measured value of the temperature.
70 SENSOR 5 TEMPERATURE (V1.21.26)
This monitoring value shows the measured value of the temperature.
71 SENSOR 6 TEMPERATURE (V1.21.27)
This monitoring value shows the measured value of the temperature.
74 WARNING (V1.21.7, V1.22.9)
This monitoring value shows the warning code of latest activated warning that is not reset.
83 TOTAL CURRENT (V1.32.2)
This monitoring value shows the total current of the drives in the Master Follower system.
1113 CURRENT (V1.18.1, V1.21.1, V1.26.1)
This monitoring value shows the unfiltered motor current.
1124 ENCODER 1 FREQUENCY (V1.21.5)
This monitoring value shows the input frequency of the encoder.
1125 TORQUE (V1.18.2, V1.21.2, V1.26.2)
This monitoring value shows the unfiltered motor torque.
1131 FINAL FREQUENCY REFERENCE CL (V1.21.22)
This monitoring value shows the final shaft frequency reference for the speed controller.
1132 STEP RESPONSE (V1.21.23)
This monitoring value shows the response for the frequency ramp step.
1140 FB TORQUE REFERENCE (V1.22.1)
This monitoring value shows the fieldbus torque reference.
1169 SHAFT ANGLE (V1.21.7)
This monitoring value shows the shaft angle from the encoder.
8
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/