Vacon NX Series Applications Manual page 315

PARAMETER DESCRIPTIONS
Table 186: Selections for parameter ID739
Selection
Selection name
number
0 Not used
1 Channel 1
2 Channel 1 and 2
3 Channel 1, 2 and 3
4 Channel 2 and 3
5 Channel 3
NOTE!
If the selected value is greater than the actual number of used sensors, the display
will read 200ºC. If the input is short-circuited the displayed value is –30ºC.
740 TBOARD FLT.RESP (RESPONSE TO PT100 FAULT) 567 (2.7.25)
Use this parameter to select the response of the drive to 'Temperature' fault.
NOTE!
The parameter name TBoard Flt.Resp is used in Multi-Purpose Control Application.
The old name (Response to PT100 fault) is still used in PID Control Application and
Pump and Fan Control Application.
Table 187: Selections for parameter ID740
Selection
Selection name
number
0 No response
1 Warning
Fault, stop mode after fault
2
according to ID506
Fault, stop mode after fault
3
always by coasting
741 TBOARD1 WARN.LIM (PT100 WARNING LIMIT) 567 (2.7.26)
Use this parameter to set the temperature warning limit.
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
VACON · 315
Description
Description
9