Vacon NX Series Applications Manual page 338

VACON · 338
Table 199: Selections for parameter ID1084
Selection
number
b0 Disables encoder fault
Update Ramp Generator when
b1 MotorControlMode changes
from TC (4) to SC (3)
RampUp; use acceleration
b2 ramp (for Closed Loop torque
control)
RampDown; use deceleration
b3 ramp (for Closed Loop torque
control)
FollowActual; follow actual
speed value within WindowPos/
b4
NegWidth (for closed loop tor-
que control)
TC ForceRampStop; Under stop
b5 request the speed limit forces
the motor to stop
b6 Reserved
Disables switching frequency
b7
decrease
Disable the parameter "Run
b8
state parameter lock"
b9 Reserved
b10 Invert delayed digital output 1
b11 Invert delayed digital output 2
1085 BRAKE ON/OFF CURRENT LIMIT 6 (2.3.4.16)
Use this parameter to set the brake current limit.
The mechanical brake closes immediately if the motor current is below this value.
This parameter is available for NXP drives only.
1087 SCALING OF GENERATING TORQUE LIMIT 6 (2.2.6.6)
Use this parameter to select the analogue input signal that adjusts the maximum motor
generating torque.
9
Selection name
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
PARAMETER DESCRIPTIONS
Description