Vacon NX Series Applications Manual page 219

PARAMETER DESCRIPTIONS
Table 111: Multi-step speed selections with digital inputs DIN3, DIN4, DIN5 and DIN6
Multi-step speed
Speed
sel. 1 (DIN4)
P2.1.22 (8)
P2.1.23 (9)
P2.1.24 (10)
P2.1.25 (11)
P2.1.26 (12)
P2.1.27 (13)
P2.1.28 (14)
P2.1.29 (15)
141 AI3 SIGNAL SELECTION * 567 (2.2.38, 2.2.4.1)
Use this parameter to connect the AI signal to the analogue input of your choice.
Connect the AI3 signal to the analogue input of your choice with this parameter. For more
information, see Chapter 9.9 "Terminal to function" (TTF) programming principle.
NOTE!
If you use an NXP drive and the Multi-Purpose Control Application (Application 6),
you can control AI3 from fieldbus when this input is set the value 0.1.
142 AI3 SIGNAL FILTER TIME 567 (2.2.41, 2.2.4.2)
Use this parameter to filter out disturbances in the analogue input signal.
When this parameter is given a value greater than 0.0 the function that filters out
disturbances from the incoming analogue signal is activated.
Long filtering time makes the regulation response slower. See parameter ID324.
143 AI3 SIGNAL RANGE 567 (2.2.39, 2.2.4.3)
Use this parameter to change the range of the analogue signal.
With this parameter you can select the AI3 signal range.
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
Multi-step speed sel.
2 (DIN5)
0 0
1 0
0 1
1 1
0 0
1 0
0 1
1 1
Multi-step speed sel. Multi-step speed
3 (DIN6)
0
0
0
0
1
1
1
1
VACON · 219
sel. 4 (DIN3)
1
1
1
1
1
1
1
1
9