Password Protection - Teledyne 2010B Operating Instructions Manual

4 Operation
Use < > arrows to blink
set appears.
Press < > arrows to blink
(You won't be able to set OFF to ON if a zero interval is entered.) A
... (or
Use arrows to set an interval value, then use < > arrows to move to the
start-time value. Use
To turn the
Press System again, choose
values screen appears, use the < > arrows to blink the
) and press Enter to go to the next screen. Use < > to select
(or
field. Use arrows to set the
these fields because there is a nonzero span interval defined.

4.3.3 Password Protection

Before a unique password is assigned, the system assigns
This password will be displayed automatically. The operator just presses the
Enter key to be allowed total access to the instrument's features.
If a password is assigned, then setting the following system parameters can
be done only after the password is entered: alarm setpoints, assigning a new
password, range/application selections, and curve algorithm linearization.
(APPLICATION and ALGORITHM are covered in the programming section.)
However, the instrument can still be used for analysis or for initiating a self-test
without entering the password. To defeat security the password must be
changed back to
NOTE: If you use password security, it is advisable to keep a copy of
the password in a separate, safe location.
4-6 Part I
, and press Enter . A new screen for
(or
...) screen appears.
arrows to set a start-time value.
and/or
and press Enter again. When the
,
.
Teledyne Analytical Instruments
), then press Enter again.
cycles (to activate
field to . You can now turn
by default.
Model 2010B
):