Password Protection; Entering The Password - Teledyne 2000A-EU Operating Instructions Manual

4 Operation
Press < > arrows to blink
won't be able to set OFF to ON if a zero interval is entered.) A
... (or
Use arrows to set an interval value, then use < > arrows to move to the
start-time value. Use
To turn the
Press System again, choose
values screen appears, use the < > arrows to blink the
) and press Enter to go to the next screen. Use < > to select
(or
field. Use arrows to set the
these fields because there is a nonzero span interval defined.

4.3.3 Password Protection

Before a unique password is assigned, the system assigns
This password will be displayed automatically. The operator just presses the
Enter key to be allowed total access to the instrument's features.
If a password is assigned, then setting the following system parameters can
be done only after the password is entered: alarm setpoints, assigning a new
password, range/application selections, and curve algorithm linearization.
(APPLICATION and ALGORITHM are covered in the programming section.)
However, the instrument can still be used for analysis or for initiating a self-test
without entering the password. To defeat security the password must be
changed back to
NOTE: If you use password security, it is advisable to keep a copy of
the password in a separate, safe location.
4.3.3.1
To install a new password or change a previously installed password, you
must key in and ENTER the old password first. If the default password is in
effect, pressing the ENTER button will enter the default
Press System to enter the System mode.
4-6
(or
SPA
...) screen appears.
arrows to set a start-time value.
and/or
and press Enter again. When the
,
.

Entering the Password

Teledyne Analytical Instruments
), then press Enter again. (You
cycles (to activate
field to . You can now turn
by default.
password for you.
Model 2000A-EU
):