Setup À Acal: Automatic Calibration; Setup Àdas: Internal Data Acquisition System; Setup À Rnge: Analog Output Reporting Range Configuration; Analog Output Ranges For Co Concentration - Teledyne T300 Operation Manual

Setup Menu
5.2. SETUP à ACAL: AUTOMATIC CALIBRATION
5.3. SETUP àDAS: INTERNAL DATA ACQUISITION SYSTEM
5.4. SETUP à RNGE: ANALOG OUTPUT REPORTING RANGE
CONFIGURATION

5.4.1. ANALOG OUTPUT RANGES FOR CO CONCENTRATION

98
Instruments with one of the internal valve options installed can be set to automatically
run calibration procedures and calibration checks. These automatic procedures are
programmed using the submenus and functions found under the ACAL menu.
A menu tree showing the ACAL menu's entire structure can be found in Appendix A-1
of this manual.
Instructions for using the ACAL feature are located in the Section 9.4 of this manual
along with all other information related to calibrating the T300/T300M Analyzer.
SAMPLE
<TST TST> CAL
SETUP X.X
CFG ACAL
Use the SETUP>DAS menu to capture and record data. Refer to Section 7 for
configuration and operation details.
Use the SETUP>RNGE menu to configure output reporting ranges, including scaled
reporting ranges to handle data resolution challenges. This section also describes
configuration for Single, Dual, and Auto Range modes.
The analyzer has several active analog output signals, accessible through the ANALOG
OUT connector on the rear panel.
Teledyne API – Model T300/T300M CO Analyzer
RANGE=50.00 PPM
PRIMARY SETUP MENU
DAS RANG PASS CLK MORE EXIT
Accesses AutoCal setup menus
CO= XX.XX
SETUP
06864B DCN6314