Setup - Analog Output Reporting Range Configuration (Rnge); Figure 6-1: Analog Output Connector Key - Teledyne 100E Instruction Manual

Model 100E Instruction Manual
In order to compensate for CPU clocks which run fast or slow, there is a variable to speed
up or slow down the clock by a fixed amount every day. To change this variable, press:
SAMPLE RANGE = 500.000 PPB
< TST TST > CAL
SETUP X.X
CFG DAS RNGE PASS CLK
SETUP X.X
COMM
VARS
SETUP X.X
8 1 8
SETUP X.X
NEXT
6.5. Setup – Analog Output Reporting Range
Configuration (RNGE)
The analyzer has three active analog output signals, accessible through a connector on
the rear panel.
LOW range when
DUAL mode is selected
045150102 Rev XB1
SO2 =X.XXX
SETUP
PRIMARY SETUP MENU
EXIT
MORE
SECONDARY SETUP MENU
DIAG EXIT
ENTER VARS PASS: 818
EXIT
ENTR
0 ) DAS_HOLD_OFF=15.0 Minutes
JUMP EDIT PRNT EXIT
SO concentration
2
outputs
A1
+ -

Figure 6-1: Analog Output Connector Key

SETUPX.X
PREV
NEXT
Continue to press NEXT until ...
SETUP X.X
PREV
SETUP X.X
+ 0 0
Enter sign and number of seconds per
day the clock gains (-) or loses (+).
SETUP X.X
PREV NEXT JUMP
ANALOG OUT
A2 A3 A4
+ - + - +
DUAL mode is selected
Operating Instructions
1 )TPC_ENABLE= ON
JUMP EDIT PRNT EXIT
8) CLOCK_ADJ=0 Sec/Day
JUMP PRNT EXIT
EDIT
CLOCK_ADJ:0 Sec/Day
EXIT
ENTR
8) CLOCK_ADJ=0 Sec/Day
EDIT PRNT
EXIT
3x EXIT returns
to the main SAMPLE display
Not Used
Test Channel
-
HIGH range when
63