Warnings And Test Measurements, Revision C.8 - Teledyne 200E Instruction Manual

Model 200E Instruction Manual
APPENDIX A-3:
Table A-2:
Name
WSYSRES SYSTEM RESET
WDATAINIT DATA INITIALIZED
WCONFIGINIT CONFIG INITIALIZED
WSAMPFLOW SAMPLE FLOW WARN
WOZONEFLOW OZONE FLOW
WARNING
WOZONEGEN OZONE GEN OFF
WRCELLPRESS RCELL PRESS WARN
WBOXTEMP BOX TEMP WARNING
WRCELLTEMP RCELL TEMP WARNING
4
WMANIFOLDTEMP MANIFOLD TEMP
WARN
WIZSTEMP IZS TEMP WARNING
WCONVTEMP CONV TEMP WARNING
WPMTTEMP PMT TEMP WARNING
WAUTOZERO AZERO WRN XXX.X MV
WHVPS HVPS WARNING
WDYNZERO CANNOT DYN ZERO
WDYNSPAN CANNOT DYN SPAN
WREARBOARD REAR BOARD NOT DET
WRELAYBOARD RELAY BOARD WARN
WFRONTPANEL FRONT PANEL WARN
WANALOGCAL ANALOG CAL
WARNING
1 Optional equipment only
044100110 Rev A

Warnings and Test Measurements, Revision C.8

M200E Warning Messages, Revision C.8
Message Text
Instrument was power-cycled or the CPU was reset.
Data storage was erased.
Configuration storage was reset to factory configuration or
erased.
Sample flow outside of warning limits specified by SFLOW_SET
variable.
Ozone flow outside of warning limits specified by OFLOW_SET
variable.
Ozone generator is off. This is the only warning message that
automatically clears itself. It clears itself when the ozone
generator is turned on.
Reaction cell pressure outside of warning limits specified by
RCELL_PRESS_SET variable.
Chassis temperature outside of warning limits specified by
BOX_SET variable.
Reaction cell temperature outside of warning limits specified by
RCELL_SET variable.
Bypass or dilution manifold temperature outside of warning limits
specified by MANIFOLD_SET variable.
IZS temperature outside of warning limits specified by IZS_SET
variable.
Converter temperature outside of warning limits specified by
CONV_SET variable.
PMT temperature outside of warning limits specified by PMT_SET
variable.
Auto-zero reading above limit specified by AZERO_LIMIT
variable. Value shown in message indicates auto-zero reading at
time warning was displayed.
High voltage power supply output outside of warning limits
specified by HVPS_SET variable.
Contact closure zero calibration failed while DYN_ZERO was set
to ON.
Contact closure span calibration failed while DYN_SPAN was set
to ON.
Rear board was not detected during power up.
Firmware is unable to communicate with the relay board.
Firmware is unable to communicate with the front panel.
The A/D or at least one D/A channel has not been calibrated.
APPENDIX A
Description
241