Appendix A-3: Warnings And Test Functions - Teledyne T300 Operation Manual

Teledyne API - T300/T300M and M300E/EM PN 04906H (DCN5840)

APPENDIX A-3: Warnings and Test Functions

Table A-2:
1
Name
WSYSRES
WDATAINIT
WCONFIGINIT
WCONCALARM1
WCONCALARM2
WSOURCE
4, 5
WAUTOZERO
WBENCHTEMP
WWHEELTEMP
10
WO2CELLTEMP
6
WSAMPFLOW
WSAMPPRESS
WSAMPTEMP
9
WPURGEPRESS
WBOXTEMP
4
WBOXTEMP2
11
WOVENTEMP
WPHOTOTEMP
WDYNZERO
WDYNSPAN
WREARBOARD
06864B DCN6314
T300/T300M and M300E/EM Warning Messages, Revision L.8
Message Text
Warnings
SYSTEM RESET
DATA INITIALIZED
CONFIG INITIALIZED
CONC ALARM 1 WARN
CONC ALARM 2 WARN
SOURCE WARNING
AZERO WARN 1.001
BENCH TEMP WARNING
WHEEL TEMP WARNING
O2 CELL TEMP WARN
SAMPLE FLOW WARN
SAMPLE PRESS WARN
SAMPLE TEMP WARN
PURGE PRESS WARN
BOX TEMP WARNING
BOX TEMP2 WARNING
OVEN TEMP WARNING
PHOTO TEMP WARNING
CANNOT DYN ZERO
CANNOT DYN SPAN
REAR BOARD NOT DET
APPENDIX A-3: Warnings and Test Functions
Description
Instrument was power-cycled or the CPU
was reset.
Data storage was erased.
Configuration storage was reset to factory
configuration or erased.
Concentration limit 1 exceeded.
Concentration limit 2 exceeded.
Reference reading minus dark offset
outside of warning limits specified by
REF_SOURCE_LIMIT variable.
Auto-reference ratio below limit specified
by ZERO_LIMIT variable.
Bench temperature outside of warning
limits specified by BENCH_SET variable.
Wheel temperature outside of warning
limits specified by WHEEL_SET variable.
O sensor cell temperature outside of
2
warning limits specified by O2_CELL_SET
variable.
Sample flow outside of warning limits
specified by SAMP_FLOW_SET variable.
Sample pressure outside of warning limits
specified by SAMP_PRESS_SET
variable.
Sample temperature outside of warning
limits specified by SAMP_TEMP_SET
variable.
Purge pressure outside of warning limits
specified by PURGE_PRESS_SET
variable.
Internal box temperature outside of
warning limits specified by BOX_SET
variable.
Internal box temperature #2 outside of
warning limits specified by BOX2_SET
variable.
Oven temperature outside of warning
limits specified by OVEN_SET variable.
Photometer temperature outside of
warning limits specified by
PHOTO_TEMP_SET variable.
Contact closure zero calibration failed
while DYN_ZERO was set to ON.
Contact closure span calibration failed
while DYN_SPAN was set to ON.
Rear board was not detected during
power up.
A-21