Remote Idas Configuration; Figure 6-6: Apicom Graphical User Interface For Configuring The Idas - Teledyne 200E Instruction Manual

Model 200E Instruction Manual Operating Instructions

6.10.3. Remote iDAS Configuration

Editing channels, parameters and triggering events as described in Section 6.9.10 is much
more conveniently done in one step through the APICOM remote control program using the
graphical interface shown in Figure 6-6. Refer to the next Section 6.11 for details on remote
access to the M200E analyzer.

Figure 6-6: APICOM Graphical User Interface for Configuring the iDAS

Once an iDAS configuration is edited (which can be done offline and without interrupting
DAS data collection), it is conveniently uploaded to the instrument and can be stored on a
computer for later review, alteration or documentation and archival. Refer to the APICOM
manual for details on these procedures. The APICOM user manual (T-API part number
039450000) is included in the APICOM installation file, which can be downloaded at
http://www.teledyne-api.com/software/apicom/.
Although T-API recommends the use of APICOM, the iDAS can also be accessed and
configured through a terminal emulation program such as HyperTerminal (Figure 6-7).
However, all configuration commands must be created following a strict syntax or be pasted
in from of a text file, which was edited offline and then uploaded through a specific transfer
procedure.
044100102 Rev A 101