Connection Of A Hmi (Human Machine Interface); Connection From Gx Works2/Gx Developer - Mitsubishi Electric Q12DCCPU-V User Manual

2
SYSTEM CONFIGURATION

(6) Connection of a HMI (Human Machine Interface)

The C Controller module can be connected to a GOT with the following methods.

(7) Connection from GX Works2/GX Developer

(a) Direct connection to the C Controller module
• Microcomputer connection through the RS-232 interface on the C Controller
*1
module
• Bus connection through an extension cable connector of a main or extension
*1*2
base unit
For the system configurations for connecting a GOT in a bus topology, refer to the
following.
Page 2-14, Section 2.1.5
• MELSECNET/H connection (PLC-to-PLC network)
• MELSECNET/10 connection (PLC-to-PLC network)
• CC-Link IE controller network connection
• CC-Link connection (intelligent device station)
• CC-Link connection (via G4)
• Ethernet connection by the 10BASE-T/100BASE-TX interface of the C Controller
*1*2
module
* 1 For applicable GOT models, refer to the following.
GOT1000 Series Connection Manual (Mitsubishi Products)
* 2 The module cannot be connected to the following C Controller modules.
• Q12DCCPU-V with a serial number whose first five digits are "12041" or earlier
• Q06CCPU-V(-B)
1) For the Q12DCCPU-V
Connection from GX Works2/GX Developer via an RS-232 interface of the C
Controller module is not allowed.
Connect the cable to the 10BASE-T/100BASE-TX interface
interface.
* 1 Connection via the 10BASE-T/100BASE-TX interface is not available with the following C
Controller modules.
• Q12DCCPU-V with a serial number whose first five digits are "12041" or earlier
* 2 For connection via the 10BASE-T/100BASE-TX interface, it is necessary to configure the built-in
Ethernet port open setting in the <<System Settings>> tab of C Controller setting utility.
For details, refer to the following manual.
C Controller Module User's Manual (Utility Operation, Programming)
For methods for connecting GX Works2/GX Developer, refer to the following.
Page App-25, Appendix 9
*1*2
*1*2
*1*2
*1*2
*1*2
2.4 Applicable Devices
1
2
3
4
5
*1 *2
or to the USB
6
7
8
2
- 29