Unmounting The Compactflash Card By The Reset/Select Switch - Mitsubishi Electric Q12DCCPU-V User Manual

6
PREPARATORY PROCEDURES AND SETTING
6.8.3 Unmounting the CompactFlash card by the RESET/SELECT
switch
The CompactFlash card can be unmounted by the RESET/SELECT switch.
Use this unmounting method only when file writing to the CompactFlash card is not in
execution.
(1) Unmounting procedure by the RESET/SELECT switch
IMPORTANT
1. Do not unmount the CompactFlash card by the RESET/SELECT switch during
2. For powering off or resetting, refer to the following.
3. If the RESET/SELECT switch is held in the RESET position by mistake, the C
Remark
file writing to the card. Doing so can cause corruption of CompactFlash card data
or a file system error.
To remove the CompactFlash card during file writing, stop access to the
CompactFlash card.
( Page 6-64, Section 6.8.2)
Page 8-9, Section 8.2.2
Controller module will be reset.
Be careful when unmounting the CompactFlash card by operating the RESET/
SELECT switch.
1) Hold the RESET/SELECT switch in the SELECT position.
When unmounting is started, the CF CARD LED on the C Controller module
starts flashing. Hold the switch in the position.
2) When unmounting is completed, the CF CARD LED turns off.
After confirming that the LED has turned off, return the switch to the central
position.
Unmounting cannot be completed if the RESET/SELECT switch is returned to
the central position before the CF CARD LED turns off.
For details of the RESET/SELECT switch operations, refer to the following.
Q12DCCPU-V: Page 6-29, Section 6.4.1 (4)
Q06CCPU-V(-B): Page 6-36, Section 6.4.2 (3)
6.8 Inserting/Removing a CompactFlash Card and Access Stop

6.8.3 Unmounting the CompactFlash card by the RESET/SELECT switch

Q12DCCPU-V Q06CCPU-V Q06CCPU-V-B
1
2
3
4
5
6
7
8
6
- 67