Mitsubishi Electric Q12DCCPU-V User Manual page 230

6
PREPARATORY PROCEDURES AND SETTING
1) Install a battery into the C Controller module.
2) Mount the C Controller module, a power supply module,
intelligent function modules, network modules, etc. on the
base unit(s).
Preparation of development environment (personal computer)
Install the following on the development environment
(personal computer).
1) SW3PVC-CCPU
2) Workbench or Tornado
1) Wire the power supply to the power supply module.
2) Connect external devices to the intelligent function
modules and I/O modules.
3) Connect the network modules.
4) When using extension base units, connect the base units
with extension cables and set base numbers.
1) Set the C Controller module to STOP. If it is in the reset
status, exit the status.
2) Configure the intelligent function module switch settings.
3) Configure the network module switch settings.
Check the following before powering on the system.
Is the power supply correctly wired?
Is the power supply voltage correct?
Initialization of C Controller module (Q12DCCPU-V only)
If "01" or "02" flashes on the 7-segment LED at the start of
the C Controller module, install a battery and perform the
following. To initialize the C Controller module, perform the
module initialization setting procedure in the hardware
self-diagnostic function.
6
- 12 6.3 Preparatory Procedure and Setting
Preparatory procedure
Module mounting
Wiring and connection
Initial setting of modules
System power-on
1
Figure 6.8 Flowchart for single CPU system startup
Page 6-48, Section 6.7.2
Page 2-17, Section 2.2
C Controller Module User's Manual
(Utility Operation, Programming),
Manual for Workbench or Tornado
QCPU User's Manual (Hardware
Design, Maintenance and Inspection),
Page 6-4, Section 6.2
Page 6-24, Section 6.4
Manual for respective module
QCPU User's Manual (Hardware
Design, Maintenance and Inspection),
Page 3-1, Section 3.1
(1) (a) in this section,
Page 6-72, Section 6.10.1