Mitsubishi Electric Q12DCCPU-V User Manual page 243

6
PREPARATORY PROCEDURES AND SETTING
Name
1) Indicator LEDs
2) 7-segment LED
3) 10BASE-T/100BASE-TX interface
4) connector (RJ45)
5) Serial number plate
6) EJECT button
CompactFlash card installation
7)
slot
8)
RUN/STOP/MODE switch
9)
RESET/SELECT switch
10) USB interface connector
11) Battery
12) Battery connector pin
13) RS-232 interface connector
Table 6.5 Part names
For the indicator LEDs, refer to the following.
(1) in this section
For the 7-segment LED, refer to the following.
(2) in this section
Used to connect a C Controller module to 10BASE-T/100BASE-TX.
(The C Controller module determines 10BASE-T or 100BASE-TX depending on
the target device.)
Indicates the serial number of the C Controller module.
Used to eject a CompactFlash card from a C Controller module.
Slot into which a CompactFlash card is installed.
(A dummy CompactFlash card is factory-installed.
For the RUN/STOP/MODE switch, refer to the following.
*2
(3) in this section
For the RESET/SELECT switch, refer to the following.
*2
(4) in this section
Used to connect the C Controller module to a USB (connector type: miniB).
Used to back up data in the standard RAM, data in the battery-backed-up RAM,
and clock data.
Used to connect a battery lead wire.
(The lead wire is disconnected from the connector before shipping to prevent
battery drain.)
Used to connect a C Controller module to an RS-232 cable.
* 1 Keep the dummy CompactFlash card in a safe place after replacing it so that it can be used again.
* 2 Operate the RUN/STOP/MODE and RESET/SELECT switches by hand.
Using a tool such as a screwdriver can cause a failure.
6.4.1 Part names and functions of the Q12DCCPU-V
Description
*1
)
6.4 Part Names and Functions
1
2
3
4
5
6
7
8
6
- 25