Mitsubishi Electric Q12DCCPU-V User Manual page 558

16
TROUBLESHOOTING
STOP
MODE I RUN
RESET SEL.
Move "n" times.
16
- 87 16.5 Hardware Self-Diagnostic Function
16.5.2 Hardware self-diagnostic test and initialization setting of the Q06CCPU-V(-B)
(c) Switching the mode
Set the RUN/STOP/MODE switch to "STOP", and select the mode by moving the
RESET/SELECT switch to the "SELECT" position.
• Mode 1
• Mode 2
• Mode 3
• Mode 1 + 2 + 3
• Default IP setting
• Standard ROM format setting:Move the RESET/SELECT switch to the
Table 16.18 Modes and corresponding LED indications (for the Q06CCPU-V)
No. Mode
1 Mode 1
2 Mode 2
3 Mode 3
4 Mode 1+2+3
5 Default IP setting
6 Standard ROM format setting
: Move the RESET/SELECT switch to the SELECT
position once. The RUN LED turns on.
: Move the RESET/SELECT switch to the SELECT
position twice.
For the Q06CCPU-V, the CF CARD LED turns on.
For the Q06CCPU-V-B, the STS LED turns on.
: Move the RESET/SELECT switch to the SELECT
position three times.
The CH2 SD/RD LED turns on.
: Move the RESET/SELECT switch to the SELECT
position four times.
For the Q06CCPU-V, the RUN LED, CF CARD
LED, and CH2 SD/RD LED turn on.
For the Q06CCPU-V-B, the RUN LED, STS LED,
and CH2 SD/RD LED turn on.
: Move the RESET/SELECT switch to the SELECT
position five times.
The USER LED turns on.
SELECT position six times.
The RUN LED and USER LED turn on.
RUN
CF CARD
CH2 SD/RD
RUN
CF CARD
CH2 SD/RD
RUN
CF CARD
CH2 SD/RD
RUN
CF CARD
CH2 SD/RD
RUN
CF CARD
CH2 SD/RD
RUN
CF CARD
CH2 SD/RD
LED indication
MODE
On On
ERR.
USER
On
MODE
On
ERR.
USER
On MODE
ERR.
On
USER
On On MODE
On
ERR.
On USER
On MODE
ERR.
On
USER
On On MODE
ERR.
On
USER