Mitsubishi Electric Q12DCCPU-V User Manual page 373

11
MULTIPLE CPU SYSTEM CONFIGURATION
11.3 Precautions for System Configuration
This section explains restrictions applied when a C Controller module is set as CPU No.1
in a multiple CPU system.
(1) Restrictions on the number of mountable modules
Product
Q series CC-Link IE controller
network module
Q series MELSECNET/H module
Q series CC-Link system master/
local module
Interrupt module
GOT
Remark
The numbers of the following modules are restricted when they are used in a multiple
CPU system.
Use them within the allowable ranges.
Table 11.6 Number of mountable modules
Model
• QJ71GP21-SX
• QJ71GP21S-SX
• QJ71BR11
• QJ71LP21-25 Up to a total of 4
• QJ71LP21S-25 modules in PLC
• QJ71LP21G to PLC network
• QJ71LP21GE
• QJ61BT11
(C Controller module can control up
• QJ61BT11N
• QI60
*2
• QX40H
*2
• QX70H
*2
• QX80H
*2
• QX90H
• GOT1000 series (only
when in bus connection)
* 1 When the interrupt event setting is specified in the following C Controller, up to 64 modules can be
inserted.
• Q12DCCPU-V with a serial number whose first five digits are "12042" or later.
* 2 The module is available only when the interrupt module is selected by setting the function selector
switch (SW2) to OFF.
For a module whose quantity is restricted when CPU No.1 is a programmable
controller CPU, refer to the following.
QCPU User's Manual (Multiple CPU System)
For the module whose quantity is restricted when CPU No.1 is Q24DHCCPU-V/-
VG/-LS or Q12DCCPU-V (Extended mode), refer to the following.
MELSEC-Q C Controller Module User's Manual
Number of mountable modules
per system
Up to 4
Up to 4
Up to 64
to 8 modules.)
*1
Up to 4
(C Controller module can control
only 1 module)
Up to 5
11.3 Precautions for System Configuration
Number of mountable modules
per CPU
Up to 4
Up to a total of 4
Up to 4
modules in PLC
to PLC network
Up to 8
*1
1
Up to 5
11
- 14
9
10
11
12
13
14
15
16