Modules From Which Inputs Can Be Loaded - Mitsubishi Electric Q12DCCPU-V User Manual

12
CONCEPT OF MULTIPLE CPU SYSTEM
<<I/O assignment settings>> tab
2) Input (X) data are loaded from the modules indicated in Table 12.10, which are
mounted on a main base unit or extension base units.
Table 12.10 Modules from which inputs can be loaded
Type setting in the
of C Controller setting utility
None
Input
Hi. input
I/O mix
Intelli.
* 1 When inputs (X) are loaded from the QX48Y57 I/O combined module, data of Xn8 to XnF that are
assigned as an output area are all off.
Xn0
Xn7
Yn8(Xn8)
YnE(XnE)
(XnF)
QX48Y57
Figure 12.9 Loading inputs (X) from QX48Y57
3) Data assigned to empty slots and cyclic data controlled by other CPUs on the
following network cannot be read out directly from the refresh target devices.
To read the following cyclic data, assign the refresh target device to the auto
refresh area in the CPU shared memory.
• CC-Link IE controller network
• MELSECNET/H
• CC-Link, etc.
(b) When "All CPUs can read all inputs" is deselected
On/off data cannot be loaded from I/O modules and intelligent function modules
controlled by other CPUs (they remain off).
12.4 Access Ranges Between a CPU Module and Other Modules
Mounted module
Input module
High-speed input module
*1
I/O combined module
Intelligent function module
Input module
High-speed input module
*1
I/O combined module
Intelligent function module
ON/OFF of inputs (X)
is loaded.
Inputs (X) are loaded
with all points OFF.
C Controller
module
12.4.2 Access to non-controlled modules
9
10
11
12
13
14
15
16
12
- 15