Mitsubishi Electric Q12DCCPU-V User Manual page 456

15
STARTING A MULTIPLE CPU SYSTEM
Utilize the CPU No.1 setting
to set the same multiple CPU system
parameters to all CPU modules.*3
Configure the system settings required
to use respective CPUs.
Write CPU No.1 parameter settings to
CPU No.1.
Write other CPU parameter settings to
respective CPU modules, No.2 and higher.
Set the switches of all CPUs from STOP
to RUN.
Reset CPU No.1. (Written parameters
take effect by resetting.)
If having replaced the C Controller module,
restart all connected devices (gateway
server, personal computers, etc.)*4
Check that all CPU modules are in the
RUN status (RUN LEDs are on).
15
- 2 15.1 Flowchart for Starting a Multiple CPU System
(From the previous page)
Setting of CPU No.2 and higher
(To the next page)
* 1 Reference section and manual are for the C Controller module.
For a programmable controller CPU, refer to the following.
QCPU User's Manual (Multiple CPU System)
* 2 Reference section and manual are for the C Controller module.
For a programmable controller CPU or Motion CPU, refer to the following.
Manual for the CPU module used
* 3 To import parameters for a multiple CPU system, use either of the following buttons.
<When CPU No.1 is a C Controller module>
Load File
Click the
<When CPU No.1 is a programmable controller CPU>
Click the
Import multiple CPU parameters
( Page 15-14, Section 15.2.4)
* 4 When having replaced the C Controller module, restart all connected devices such as gateway
server and personal computer.
(If the connected device retains an Ethernet address of its communication target, the Ethernet
address is changed and continued communication may be disabled after the replacement.)
Likewise, restart the C Controller module when a connected device has been replaced.
Page 15-14, Section 15.2.4
Section 9.1.6, 17.2.4*2
C Controller Module User's Manual
(Utility Operation, Programming)
C Controller Module User's Manual
(Utility Operation, Programming)
C Controller Module User's Manual
(Utility Operation, Programming)
Q12DCCPU-V: Page 6-29, Section 6.4.1 (3)
Section 5.4 (2)*2
Q06CCPU-V(-B): Page 6-35, Section 6.4.2 (2)
Page 12-21, Section 12.6 ,
Section 13.6, 5.4 (3)*1
Q12DCCPU-V: Page 6-29, Section 6.4.1 (4)
Q06CCPU-V(-B): Page 6-36, Section 6.4.2 (3)
Q12DCCPU-V: Page 6-26, Section 6.4.1 (1)
Section 5.4 (1)*2
Q06CCPU-V(-B): Page 6-33, Section 6.4.2 (1)
button of C Controller setting utility.
button of C Controller setting utility.
*2
*2
*1
*2
*2
*1
*2