Mitsubishi Electric Q12DCCPU-V User Manual page 253

6
PREPARATORY PROCEDURES AND SETTING
(2) RUN/STOP/MODE switch operation
Position
In normal operation mode
RUN In hardware self-
diagnostic operation
mode
The operation of the C Controller module is stopped.
STOP
Switching from RUN to STOP turns off all outputs (Y).
(Output (Y) from a user program and writing to the buffer memory are disabled.)
MODE
Used for the hardware self-diagnostic function. (
STOP
MODE RUN
Figure 6.29 The RUN/STOP/MODE switch
Table 6.14 RUN/STOP/MODE switch operation
The C Controller module is operating.
(Output (Y) from a user program and writing to the buffer memory are enabled.)
For the hardware self-diagnostic function, refer to the following.
Page 16-84, Section 16.5.2
* 1 Operations such as forced output (Y) and buffer memory writing can be executed from the
<<Module monitoring>> tab of C Controller setting utility.
6.4.2 Part names and functions of the Q06CCPU-V(-B)
Operation
*1
Page 16-84, Section 16.5.2)
6.4 Part Names and Functions
1
2
3
4
5
6
7
8
6
- 35