Error Details; Error Codes Related To S(P).Gint And D(P).Gint Instructions - Mitsubishi Electric Q12DCCPU-V User Manual

13
COMMUNICATIONS BETWEEN CPU MODULES
Sequence program
S(P). GINT instruction
C Controller module interrupt
routine (interrupt program)
C Controller module user
program
SM391 (S(P).GINT instruction
execution completed flag)
Error code
(d) Operation timing
END
OFF
Interrupt routine (interrupt
program) executed
Interrupt routine (interrupt program)
in waiting status
QBF_Wait Event function
executed
Interrupt event in waiting status by user program
ON
OFF
*1 Interrupt event notified after the interrupt routine (interrupt program) ends.
Figure 13.7 Operation timing of the S(P).GINT instruction
(e) Error details
In any of the following cases, an operation error occurs, the error flag (SM0) of the
programmable controller CPU is set to ON, and an error code is stored in SD0.
Table 13.6 Error codes related to S(P).GINT and D(P).GINT instructions
*1
CPU No. of a reserved ("Empty" setting) or non-mounted
2110
CPU is specified for the target CPU start I/O No.
The originating CPU is specified for the target CPU start I/O
2114
No. 16 (n1).
A module that does not support the S(P).GINT and
D(P).GINT instructions is specified for the target CPU start I/
2117
O No. 16 (n1).
Any of 0 to 3DF
4100
start I/O No.
* 1 0000 (Normal)
H
END
S(P).GINT instruction executed
ON
Interrupt issued
Interrupt routine (interrupt program) in waiting status
Interrupt event notified
User program resumed
S(P).GINT instruction executed
S(P).GINT instruction not executed
Cause
, or 3E4 is specified for the target CPU
H H
16 (n1).
13.2 Interrupt from Another CPU
END END
*1
Action
16 (n1).
Check and
correct the
sequence
program.
13
9
t
10
11
12
13
14
15
16
- 9