Connection Between Cc-Link Interface Card And Master Station; Connection Of One-Touch Connector And Cable Only For Cc-Link - Mitsubishi Electric MELFA CR800-D Series Instruction Manual

6.2. Connection Between CC-Link Interface card and Master Station

Explain the connection method for the CC-Link interface card mounted in the robot controller, and
the CC-Link master-station unit.

6.2.1. Connection of one-touch connector and cable only for CC-Link

Connection method of the cable for CC-Link only prepared by the customer and one-touch connector
attached to this product is shown in the following.
(1) Peel covering of the cable only for CC-Link (It is not necessary to peel covering of the internal
cable)
(2) Insert the electric wire of the cable for CC-Link to the one-touch connector.
(3) Close the connector with pliers
(4) Complete
・ ・ ・ ・ ・
21
Signal name
DA(Blue)
DB(white)
DG(Yellow)
NC
SLD