Part Names - Mitsubishi Electric Q12DCCPU-V User Manual

6
PREPARATORY PROCEDURES AND SETTING
Name
1) Indicator LEDs
10BASE-T/100BASE-TX interface
2)
connector (RJ45)
3) RS-232 interface connector
4) Serial number plate
5)
RUN/STOP/MODE switch
6)
RESET/SELECT switch
7) EJECT button (Q06CCPU-V only) Used to eject a CompactFlash card from a C Controller module.
CompactFlash card slot
8)
(Q06CCPU-V only)
9) Battery
10) Battery connector pin
6
- 32 6.4 Part Names and Functions
6.4.2 Part names and functions of the Q06CCPU-V(-B)
Table 6.11 Part names
For the indicator LEDs, refer to the following.
(1) in this section
Used to connect a C Controller module to 10BASE-T/100BASE-TX.
(The C Controller module determines 10BASE-T or 100BASE-TX depending on
the target device.)
Used to connect a C Controller module to an RS-232 cable.
Indicates the serial number of the C Controller module.
For the RUN/STOP/MODE switch, refer to the following.
*2
(2) in this section
For the RESET/SELECT switch, refer to the following.
*2
(3) in this section
Slot into which a CompactFlash card is installed.
(A dummy CompactFlash card is factory-installed.
Used to back up data in the standard ROM, data in the battery-backed-up RAM,
and clock data.
Used to connect a battery lead wire.
(The lead wire is disconnected from the connector before shipping to prevent
battery drain.)
* 1 Keep the dummy CompactFlash card in a safe place after replacing it so that it can be used again.
* 2 Operate the RUN/STOP/MODE and RESET/SELECT switches by hand.
Using a tool such as a screwdriver can cause a failure.
Description
*1
)