Output (Y) Status Setting For Switching Stop To Run; Setting Applications - Mitsubishi Electric Q12DCCPU-V User Manual

4
FUNCTIONS
4.6

Output (Y) Status Setting for Switching STOP to RUN

(1) Output (Y) status setting for changing the status from STOP to RUN
When the C Controller module status is switched from RUN to STOP, the output data
(Y) in the RUN status are saved in the C Controller module and actual outputs are all
turned off.
In the STOP status, the output (Y) status cannot be changed from the user program.
Either of the following two options can be selected for the case of switching STOP to
RUN.

(2) Setting applications

When the C Controller module status is changed from STOP to RUN, whether to
resume the previous output or not can be selected in advance.
• Outputting the output status data before STOP. (Previous state)
• Clearing the output (Y) data. (Reset output (Y))
• When "Previous state" is selected
Output (Y)
Figure 4.6 Timing chart for "Previous state" setting
• When "Reset output (Y)" is selected
Output (Y)
Figure 4.7 Timing chart for "Reset output (Y)" setting
4.6 Output (Y) Status Setting for Switching STOP to RUN
Q12DCCPU-V Q06CCPU-V
RUN STOP STOP
RUN STOP STOP
1
Q06CCPU-V-B
2
3
4
RUN
5
RUN
6
7
8
4
- 26