Sequence Program Control Function - Mitsubishi Electric Q12DCCPU-V User Manual

13
COMMUNICATIONS BETWEEN CPU MODULES
13.5

Sequence Program Control Function

(1) Sequence program control function
Programmable controller CPU
Sequence program
Scan execution type
program
Standby type program
Remark
This function allows the C Controller module to control (change) the sequence
program execution type of a programmable controller CPU.
Use a bus interface function when creating a user program for the C Controller
module.
Low speed execution
type program
1)
Fixed scan execution
type program
Figure 13.30 Sequence program control
1) For the bus interface functions, refer to the following.
C Controller Module User's Manual (Utility Operation, Programming)
2) For this function, use a High Performance model QCPU.
Q12DCCPU-V
C Controller module
/* Controls the execution type of the sequence program */
ret = QBF_ControlProgram(path, cpuno, programname, type, interval);
1) Controls the execution type of the sequence
program from the C Controller module.
13.5 Sequence Program Control Function
Q06CCPU-V Q06CCPU-V-B
13
- 43
9
10
11
12
13
14
15
16