Connecting A Safety Function Device - YASKAWA SGD7S series Product Manual

Sigma-7-series ac servo drive. sigma-7s servopack with analog voltage/pulse train references

Hide thumbs Also See for SGD7S series:

Table of Contents

11.6 Connecting a Safety Function Device

Use the following procedure to connect a safety function device.

Remove the Safety Jumper Connector from the connector for the safety function device

Connect the safety function device to the connector for the safety function device

Note: If you do not connect a safety function device, leave the Safety Jumper Connector connected to the connec-

tor for the safety function device (CN8). If the SERVOPACK is used without the Safety Jumper Connector

connected to CN8, no current will be supplied to the Servomotor and no motor torque will be output. In this

case, Hbb will be displayed on the Digital Operator.

Hold the afety Jumper

Connector between your

afety Jumper

finger and remove it.

Sgd7s-****00a series