YASKAWA SGD7S series Product Manual page 606

Parameter
Name
No.
*7
Pn61B
2 Overheat Alarm Level
*7
Pn61C
2 Overheat Warning Level
Overheat Alarm Filter
*7
Pn61D
2
Time
Pn621 to
Safety Module-Related
–
*2
Parameters
Pn628
*1.
Set a percentage of the motor rated torque.
*2.
These parameters are for SERVOPACKs with a Safety Module. Refer to the following manual for details.
Σ-V-Series/Σ-V-Series for Large-Capacity Models/Σ-7-Series User's Manual Safety Module (Manual No.: SIEP
C720829 06)
*3.
Normally set this parameter to 0. If you use an External Regenerative Resistor, set the capacity (W) of the Exter-
nal Regenerative Resistor.
*4.
The upper limit is the maximum output capacity (W) of the SERVOPACK.
*5.
These parameters are for SERVOPACKs with the dynamic brake option. Refer to the following manual for details.
Σ-7-Series AC Servo Drive Σ-7S/Σ-7W SERVOPACK with Dynamic Brake Hardware Option Specifications Prod-
uct Manual (Manual No.: SIEP S800001 73)
*6.
The SGLFW2 is the only Yaskawa Linear Servomotor that supports this function.
*7.
Enabled only when Pn61A is set to n.2 or n.3.
Setting Setting Default
Range Unit Setting
0 to 500 0.01 V 250
0 to 100 1% 100
0 to 65,535 1 s 0
− − −
14.1 List of Parameters
14.1.2 List of Parameters
Continued from previous page.
Applicable When Classi-
Motors Enabled fication
Immedi-
All Setup
ately
Immedi-
All Setup
ately
Immedi-
All Setup
ately
− −
All
Refer-
ence
page
6-109
page
6-109
page
6-109
−
14
14-33