YASKAWA SGD7S series Product Manual page 148

6.
Select Edited Parameters in the Write to Servo Group.
The edited parameters are written to the SERVOPACK and the backgrounds of the cells change to
white.
7.
Click the OK Button.
8.
To enable changes to the settings, turn the power supply to the SERVOPACK OFF and
ON again.
This concludes the procedure to set the parameters.
Setting Parameters with a Digital Operator
Refer to the following manual for information on setting the parameters with a Digital Operator.
Σ-7-Series Digital Operator Operating Manual (Manual No.: SIEP S800001 33)
Setting Parameters with the Panel Operator
Refer to the following section for information on setting the parameters with the Panel Operator.

13.2 Parameter (Pn ) Operations on the Panel Operator on page 13-6
5.1 Manipulating Parameters (Pn)
5.1.3 Parameter Setting Methods
5
5-7