Adjust Analog Monitor Output Offset (Fn00C); Adjust Analog Monitor Output Gain (Fn00D) - YASKAWA SGD7S series Product Manual
Sigma-7-series ac servo drive.
sigma-7s servopack with
analog voltage/pulse train references
Hide thumbs
Also See for SGD7S series:
- Product manual (621 pages) ,
- Selection manual (337 pages) ,
- Product manual (473 pages)
Table of Contents
Advertisement
13.4 Utility Function (Fn) Operations on the Panel Operator
13.4.11 Adjust Analog Monitor Output Offset (Fn00C)
13.4.11 Adjust Analog Monitor Output Offset (Fn00C)
Refer to the following section for information on this utility function other than the procedure.
Adjusting the Analog Monitor Output on page 9-12
Step
1
2
3
4
5
6
7
8
9
10
13.4.12 Adjust Analog Monitor Output Gain (Fn00D)
Refer to the following section for information on this utility function other than the procedure.
Adjusting the Analog Monitor Output on page 9-12
Step
1
2
3
4
13-20
Panel Display after
Operation
MODE/SET
MODE/SET
MODE/SET
MODE/SET
MODE/SET
MODE/SET
MODE/SET
MODE/SET
MODE/SET
MODE/SET
Panel Display after
Operation
MODE/SET
MODE/SET
MODE/SET
MODE/SET
Keys
Press the MODE/SET Key to enter Utility Function
Mode.
DATA/
Press the UP Key or DOWN Key to display Fn00C.
DATA/
Press the DATA/SHIFT Key for approximately one sec-
ond. The display shown at the left will appear.
DATA/
Press the DATA/SHIFT Key. The offset will be dis-
played as shown on the left.
DATA/
Press the UP Key or DOWN Key to adjust the offset.
DATA/
Press the DATA/SHIFT Key. The display shown on the
left will appear again.
DATA/
Press the MODE/SET Key. The display will change to
the monitor output for channel 2 (analog monitor 2 out-
put).
DATA/
Press the DATA/SHIFT Key. The offset will be dis-
played as shown on the left.
DATA/
Press the UP Key or DOWN Key to adjust the offset.
DATA/
Press the DATA/SHIFT Key for approximately one sec-
ond. Ch2-o will be displayed, and then Fn00C will be
DATA/
displayed again.
Keys
Press the MODE/SET Key to enter Utility Function
Mode.
DATA/
Press the UP Key or DOWN Key to display Fn00D.
DATA/
Press the DATA/SHIFT Key for approximately one sec-
ond. The display shown at the left will appear.
DATA/
Press the DATA/SHIFT Key. The gain adjustment will
be displayed as shown on the left.
DATA/
Operation
Operation
Continued on next page.
Advertisement
Table of Contents
Troubleshooting
