Power Off, Remote (Oracle Ilom Cli) - Oracle X5-8 Service Manual

Use this procedure when you are at the server to immediately power off the server to standby
power mode.
Physical access to the server front panel is required.
Before You Begin ■
Press and hold the Power button for at least five seconds until full power turns
1.
off and the server enters standby power mode.
2. Verify that the server is in standby power mode.
When the server is in standby power mode, the SP indicator is on steady, and the Power OK
indicator blinks at the single blink rate (a quick flash every three seconds).
"Performing Electrostatic Discharge and Static Prevention Measures" on page 90
Next Steps ■

Power Off, Remote (Oracle ILOM CLI)

You can use the Oracle ILOM SP command-line interface (CLI) to remotely power off the
server to standby power mode.
See: "Power Modes, Shutdowns, and Resets" on page 107
Before You Begin
1. Open an SSH session and at the command line log in to the SP Oracle ILOM CLI.
Log in as a user with root or administrator privileges. For example:
ssh root@
ipadress
Power Off, Remote (Oracle ILOM CLI)
Preparing for Service 103