Servicing The Sas Cable - Oracle X5-8 Service Manual

Replace the SAS Cable
The connector on the ESM is at the end of a cable that dangles about four inches out of the
ESM body.
Inspect the cable to make sure that it is routed correctly and connected to the
13.
ESM and the HBA.

Servicing the SAS Cable

This section contains information about the SAS cables:
"Replace the SAS Cable" on page 214
■
Replace the SAS Cable
This is an internal component that is accessible from the rear of the server by removing the
SMOD. Perform this procedure to replace the SAS cables on the SMOD.
For component serviceability, locations, and designations, see
Before You Begin ■
Designations" on page
214 Oracle Server X5-8 Service Manual • December 2015
79.
"Component Locations, and