Preparing For Service; Prepare The Server For Hot Service - Oracle X5-8 Service Manual

Preparing for Service

This section includes preliminary information and procedures that assist you with preparing to
service the server. The following table describes the contents of this section.
Section Description
Setting up for hot service.
Setting up for warm service
Setting up for cold service.
Server power-off options.
Methods for activating and deactivating the
server Locator indicator.

Prepare the Server for Hot Service

Note -
procedure can also be performed remotely using the Oracle ILOM CLI interface. For more
information, refer to the Oracle ILOM documentation.
A hot-service component can be serviced while the server is operating at full-power mode.
For more information about component serviceability, see
Requirements" on page
This procedure describes how to prepare the server to remove, replace, or install the following
hot-service components:
Fan modules
■
Power supplies
■
Storage drives
■
Dual PCIe Card Carriers (DPCCs)
■
Important: Review the
■
Before You Begin
before performing removal and installation procedures.
The steps in this remote procedure use the Oracle ILOM web interface. However, the
79.
Oracle Server X5-8 Product Notes
Link
"Prepare the Server for Hot Service" on page 95
"Prepare the Server for Warm Service" on page 96
"Prepare the Server for Cold Service" on page 98
"Powering Off the Server" on page 100
"Managing the Locator Indicator" on page 108
"Component Serviceability
for hardware-related information
Preparing for Service 95